These studs fit 1927-1959 Chevrolet & GMC cars & trucks. They are replacements for the stud that the tie rod ends, drag link ends and idler arms mount onto. To install a new ball, use a 1/2" drill bit and drill the bottom of the shank down about 1/8. Press out the ball in a hydraulic press. Press in the new ball stud. CAUTION: Be sure the new ball is fully seated in the arm and down tight (clamp in place if necessary). Weld the new ball stud in place. Have a certified welder do this job to assure a good quality weld since a failure of this part could be catastrophic. DIMENSIONS: 1" DIA. BALL WITH .532" SHANK
1927-1959 Passenger & 1/2 Ton Truck - TIE ROD ONLY;
1934-1946 1/2 Ton Truck - DRAG LINK ONLY;
1949-1954 Passenger - IDLER ARM ONLY
This part fits most 1949 1950 1951 1952 1953 1954 Chevrolet Cars and Trucks.; exceptions may apply. Please read the complete description to see if this part fits your specific vehicle and application.
This product can expose you to a chemical, which is known to the State of California to cause cancer or reproductive harm.
For more information go to www.P65Warnings.ca.gov