FAX: (541) 258-6968v
 
New CustomersLogin
  1. The Filling Station »
  2. 1939 Chevrolet Car Parts »
  3. Steering »
  4. Tie Rods »
Filters
Vehicle: Car - Switch To Truck / All
Year: 1939 - Clear Filter

Ball Studs
Chevrolet Parts - 1927-59 TIE ROD-DRAG LINK BALL STUD - THREADED
SA-157T
USD $21.95 EA
Buy 2+: $19.95
CHEVROLET 1927-59 TIE ROD-DRAG LINK BALL STUD - THREADED
These studs fit 1927-1959 Chevrolet & GMC cars & trucks. They are threaded replacements for the stud that the tie rod ends & drag link ends mount onto. To install a new ball, use a 1/2" drill bit and drill the bottom of the shank down about 1/8. Press out the ball in a hydraulic press. Press in the new ball stud. CAUTION: Be sure the new ball is fully seated in the arm and down tight (clamp in place if necessary). Dimensions: 1" Diameter Ball with .532" Diameter Stud Specific Applications: 1927-1959 Passenger & 1/2 Ton Truck - TIE ROD ONLY; 1934-1946 1/2 Ton Truck - DRAG LINK ONLY

For 1927 1928 1929 1930 1931 1932 1933 1934 1935 1936 1937 1938 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 1956 1957 1958 1959 Chevrolet Cars and Trucks
Dust Seals
Chevrolet Parts - 1939-1966 TIE ROD END DUST SEAL
CV-96
USD $8.95 EA
CHEVROLET 1939-1966 TIE ROD END DUST SEAL
This is a rubber tie rod end seal for 1939-1966 Chevrolet & GMC cars & trucks. Up to four required per vehicle. Replaces GM# 3687643 Specific Applications: 1939-1952: All Passenger (exc 1939-1940 Straight Axle Models - JB, KB); 1953-1964: All full size & Corvette; 1960-1962: Chevy & GMC 1/2 Ton Trucks; 1963 Series 20 3/4 Ton 4WD; 1964-1966 4WD Trucks

For 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 1956 1957 1958 1959 1960 1961 1962 1963 1964 1965 1966 Chevrolet Cars and Trucks
Repair Kits
Chevrolet Parts - 1927-1959 TIE ROD & DRAG LINK REPAIR KIT
FS-148
USD $36.95 KIT
CHEVROLET 1927-1959 TIE ROD & DRAG LINK REPAIR KIT
QUALITY MATTERS ON THIS IMPORTANT STEERING COMPONENT! This Tie Rod End or Drag Link End Repair Kit fits 1927-1959 Chevrolet cars & Chevy & GMC trucks. Yes, there are cheaper repair kits available, but this is a true case of "you get what you pay for!" Kits include: pistons - cups, springs and plugs to replace all internal parts of two tie rod or drag link ends. Spring dimensions: OD .929" x ID .570" x .830" Overall Length. NOTE: This kit WILL NOT WORK on 1930-1931 Tie Rod Ends!! Replaces GM# 601148, 608840 Specific Applications are: 1927-1952 Commercial (exc. Utility) - DRAG LINK ENDS; 1927-1954 Passenger - DRAG LINK ENDS; NOTE: 1937-1938 Master (GB & HB) Require 2 kits to repair the drag link ends. 1932-1938 All (exc. 1933-1936 Standard Pass, 1937-1938 Pass with Straight Axle - Models CC,DC,EC,FC,GB,HB) - TIE ROD ENDS; 1939-1942 Commercial (exc. Utility) - TIE ROD ENDS; 1946-1959 Commercial (exc. Utility, D-D) - TIE ROD ENDS.

For 1927 1928 1929 1930 1931 1932 1933 1934 1935 1936 1937 1938 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 1956 1957 1958 1959 Chevrolet Cars and Trucks
Tie Rod Assemblies
Chevrolet Parts - 1939-1948 PASS TIE ROD ASSEMBLY - SHORT
FS-556
Wait List
CHEVROLET 1939-1948 PASS TIE ROD ASSEMBLY - SHORT
This is the short tie rod for all 1939-1948 Chevrolet passenger cars with independent suspension or open knee front end. The assembly comes with the short sleeve and two adjustable ends. Sleeve is 11" long. Threads are 9/16"-18. Replaces GM# 599241.

For 1939 1940 1941 1942 1944 1945 1946 1947 1948 Chevrolet Cars
Chevrolet Parts - 1937-1940 CAR TIE ROD-STRAIGHT AXLE MODELS
CD-121
USD $64.95 EA
CHEVROLET 1937-1940 CAR TIE ROD-STRAIGHT AXLE MODELS
This is the steel rod that attaches to the tie rod ends for 1937-1940 Chevrolet passenger cars with Straight Axle. It is the proper length and diameter. It is threaded on both ends for the left & right tie rod ends. Replace yours if it is bent to get more accurate wheel alignment. Made in the USA! Dimensions: 43-1/8" Long with 11/16"-16 Thread, 11/16" OD. Replaces GM# 593047 Specific Applications: 1937-1940 Passenger cars with Straight Axle - Models GB, HB, JB, KB Only NOTE: This item must be shipped in a tube. A tube charge of $8.00 will be applied, in addition to freight charges.

For 1937 1938 1939 1940 Chevrolet Cars
Chevrolet Parts - 1932-1954 CAR/TRUCK TIE ROD-LESS ENDS
CD-27
USD $69.95 EA
CHEVROLET 1932-1954 CAR/TRUCK TIE ROD-LESS ENDS
This is the steel rod that attaches to the tie rod ends for 1932-1955 Chevrolet & GMC cars & trucks. It is the proper length and diameter. It is threaded on both ends for the left & right tie rod ends. Replace yours if it is bent to get more accurate wheel alignment. Made in the USA! Dimensions: 43-3/16" Long with 25/32"-16 Thread, 13/16" OD. Replaces GM# 367500, 367528 Specific Applications: 1932-1936: All Pass & Truck except 1933-1936 Standard; 1937-1942: All Commercial - 1/2 to 1 Ton; 1946-1955(1st series) 1/2 and 3/4 ton NOTE: This item must be shipped in a tube. A tube charge of $8.00 will be applied, in addition to freight charges.

For 1932 1933 1934 1935 1936 1937 1938 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 Chevrolet Cars and Trucks
Tie Rod Ends
Chevrolet Parts - 1939-1954 PASSENGER CAR TIE ROD END - LEFT
FS-1L
USD $26.95 EA
CHEVROLET 1939-1954 PASSENGER CAR TIE ROD END - LEFT
This is a Tie Rod End for 1939-1954 Chevrolet passenger cars (exc. JB,KB models with straight axle). It has a 9/16"-18 Thread. Specify Right or Left when Ordering. Replaces GM# 3692951, 3692952, Casting # 3691955, 3691956

For 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 Chevrolet Cars
Chevrolet Parts - 1939-1954 PASSENGER CAR TIE ROD END - RIGHT
FS-1R
USD $26.95 EA
CHEVROLET 1939-1954 PASSENGER CAR TIE ROD END - RIGHT
This is a Tie Rod End for 1939-1954 Chevrolet passenger cars (exc. JB,KB models with straight axle). It has a 9/16"-18 Thread. Specify Right or Left when Ordering. Replaces GM# 3692951, 3692952, Casting # 3691955, 3691956

For 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 Chevrolet Cars
Chevrolet Parts - 1932-1959 CAR/TRUCK TIE ROD ENDS-REPLACEMENT
AF-168
USD $64.95 PR
CHEVROLET 1932-1959 CAR/TRUCK TIE ROD ENDS-REPLACEMENT
These tie rod ends replace the original housings completely. They come with a fixed ball stud, like a modern tie rod end. You must remove the original ball stud to install this tie rod end. Replaces GM# 374226, 374227 Specific Applications: 1932-1938 Passenger cars & trucks (Except 1933-1936 Std & 1937-1938 Master w/straight axle); 1937-1942 1 Ton Trucks; 1937-1954 3/4 Ton Trucks; 1937-1959 1/2 Ton Trucks Dimensions: 13/16" OD x 5" OL, Center stud to end is 4"; 16 threads per inch; 3/4" UNF. Diameter of stud is .525" to .540" tapered.

For 1932 1933 1934 1935 1936 1937 1938 1939 1940 1941 1942 1944 1945 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 1956 1957 1958 1959 Chevrolet Cars and Trucks
Chevrolet Parts - 1939-1948 Passenger FIXED TIE ROD - REPLACEMENT
ML-6
USD $115.95 EA
CHEVROLET 1939-1948 Passenger FIXED TIE ROD - REPLACEMENT
This is a replacement for the long side fixed tie rod that fits all 1939-1948 Chevrolet passenger cars (except straight axle models). The rod is 26-3/4" long and has adjustable ends. Each end is 4-3/4" OL. One end of the tube and one tie rod end are right hand threads and one end has left hand threads. Replaces GM# 605923.

For 1939 1940 1941 1942 1944 1945 1946 1947 1948 Chevrolet Cars
  1. The Filling Station »
  2. 1939 Chevrolet Car Parts »
  3. Steering »
  4. Tie Rods »
Filters
Vehicle: Car - Switch To Truck / All
Year: 1939 - Clear Filter

Copyright ©2025 The Filling Station, LLC
E-mail: fssales@fillingstation.com