This is a Dowel Pin used to secure original type Torque Tube Bushings for 1925-1950 Chevrolet & GMC cars & trucks. Not required for bushing & seal assemblies (V-101,V-102,& V-105) which are press fit bushings. Replaces GM# 347813

This driveshaft bushing fits all 1930-1933 Chevrolet passenger cars & 1/2 ton trucks. Dimensions: 1-1/32" ID x 1-1/2" OD x 1-1/2" Long. The bushing comes with a dowel pin for installation. Made in the USA! Replaces GM# 373507 Specific Applications: 1930-1933 Passenger & 1/2 Ton (exc 1933 Std) - Models AD, BA, BB, CA, CB A worn drive shaft bushing causes annoying vibration and excessive wear to the drive shaft and universal joint. A worn seal permits the transmission fluid to drain back to the rear axle - overfilling the differential and causing the transmission to run dry. See also RW-5 drive shaft seal and FS-125 U-joint gasket set. Remove old front bushing by drilling out the old dowel pin. With a punch, drive the bushing out of the front of the tube. This exposes the old cork seal. Use compressed air or a thin screwdriver to remove the remains of the cork. Lubricate and install the new seal (RW-5 - sold separately) with the lip facing to the transmission. Lubricate the new bushing with gear oil and drive into place. Drill a new hole in the tube and install the dowel pin to lock the bushing in place. Install new ball housing gaskets (FS-125 & FS-4356 - sold separately). Reinstall U-joint and tighten 4 cap screws that hold the collar in place. Fill ball housing with about 1/2 pint of 600 WT gear oil (VT-40) through the plug on top of the rear transmission housing. Check transmission fluid level and fill as necessary.

This is a Drive Shaft Coupler for 1930-1933 Chevrolet cars & 1/2 ton trucks. This is a LIMITED SUPPLY ITEM. Availability is subject to stock on hand. Replaces GM# 357397 Specific Applications: 1930-1933 Passenger (exc 1933 Standard); 1930-1933 1/2 Ton Trucks