Item ID:
LED-6025
Make:
Chevrolet
Weight:
1.1000lbs.
These flush mounted LED Tail Light Assemblies fit 1941-1948 Chevrolet passenger cars or as a custom car feature on any vehicle.
.
Product Details: Complete taillamp assembly with very bright and visible LEDs for the stop, tail, and turn signal function. LEDs feature a wide viewing angle of 100 degrees as well as cool operation and long life. This lamp is designed to bolt into a 1941-48 Chevy in place of the original taillight. Surface mount design with no bucket. Great solution for cars with clearance problems (rumble seat or tire) or new installations. Requires drilling only three small holes in new installations. May be used with three or four wire connection (ground, taillight, stoplight, turnsignal). Includes RapidFire brake lights and modulated taillights for maximum vehicle visibility. 12 volt required.
Construction: Includes stainless steel base plate, stainless steel studs, nuts, and washers, custom designed acrylic lens to maximize the LEDs visibility, lens has built-in reflector for lights off safety, stainless steel bezel, custom molded taillamp to body seal. Completely assembled in our Indiana factory.
Installation Time: About 30 minutes.
LEDs: 14 high intensity LEDs per lamp with 100 degree viewing angle and rugged four pin design.
Kit Contents:(2) LED complete taillamp assemblies, (4) solderless connectors, (2) LED to car electrical harness, (2) custom molded taillamp to body seal, installation instructions.
This part fits most 1941 1942 1946 1947 1948 Chevrolet Cars; exceptions may apply. Please read the complete description to see if this part fits your specific vehicle and application.
This product can expose you to a chemical, which is known to the State of California to cause cancer or reproductive harm.
For more information go to www.P65Warnings.ca.gov
