Item ID:
PA-33
Make:
Chevrolet
Weight:
5.0000lbs.
In 1955, used on 1st Series only. DO NOT USE WITH IN-DASH RADIO. This kit completely replaces the factory vacuum wiper system. It comes with a 12 volt, ten amp, two-speed electric motor. Complete with bracketing, linkage arms, wiper transmissions, wiring and switch. Designed to fit neatly under the dash.
Order this kit if you want standard two-speed wiper operation. Also available is the same kit with wiper delay switch - see PA-33D. Use with your original wiper arms, blades & chrome trim. A top quality product Made in the USA!
The RainGear system will fit all 1947 to 1954 Chevrolet and GMC trucks with the following exceptions:
On 1954 trucks only, the stock defroster ducts will not clear our system. When installing our system into a 54 either use the ducts from a 47-53 truck or ducts from one of the aftermarket A/C system suppliers.
Original radios in the upper dash board mount location will not clear our system. We have one report of an aftermarket radio interfering as well.
Cross-mount master cylinders likely wont fit with our RainGear system installed.
The kit comes complete less assembly lube, arms and blades, escutcheons and model-specific knobs for the switch. All those stock pieces will fit on our system. Escutcheons are the exterior trim bezels which cover the pivot posts in the cowl.
Please note that the RainGear unit cannot be controlled by any General Motors column-mounted wiper switches. You must use the included switch. This is due to the fact that GM switches control the wiper motor via the ground wire and our systems must be controlled by switching the positive wire.
This part fits most 1947 1948 1949 1950 1951 1952 1953 1954 1955 Chevrolet Trucks; exceptions may apply. Please read the complete description to see if this part fits your specific vehicle and application.
This product can expose you to a chemical, which is known to the State of California to cause cancer or reproductive harm.
For more information go to www.P65Warnings.ca.gov